• • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • 3 – 7
Using The Scan Tool
3
AC Power Adapter
An AC power adapter (not included) can be used to power the Scan Tool
when reprogramming from a personal computer or for off-vehicle
reviewing of codes and printing.12V AC-DC converters are available at
most PC and electronic stores.
✓The Scan Tool is equipped to accept any
110 VAC - 12 VDC wall adapter with the
following specifications:
❒500 mA minimum current unregulated wall power adapter
❒5.5 mm outside diameter
❒2.5 mm inside diameter
❒The inside tip is positive (+)
Scan Tool Power UP
1. Connect Power Source
•
Internal Battery
(9V Battery), or vehicle Power DLC
• AC Adapter, or cigarette lighter cable.
2. Press and Hold
ON/OFF
key
•
For 1 second until the Scan Tool turns on.
System Setup
✓System Setup allows:
❒Measurement units to be changed.
❒Display contrast to be changed.
❒Auto-Power off time to be changed.
❒Scan Tool information to be viewed.
❒Display to be checked.
❒Operation of the keypad to be checked.
❒Memory of the tool to be checked.
❒Scan Tool to be upgraded, or programmed for a different
language.
12 VGND