Basic Host Adaptec Settings | Default |
Host Adapter SCSI ID | 7 |
SCSI Parity Checking | Enabled |
Host Adapter SCSI Termination | Low ON/High ON |
|
|
Boot Device Settings | Default |
|
|
Boot Target ID | 0 |
Boot LUN Number1 | 0 |
|
|
|
|
|
|
SCSI Device Settings | Default |
|
|
Initiate Sync Negotiation | Yes (Enabled) |
Maximum Sync Transfer Rate | Yes (Enabled) |
Enable Disconnection | 20 MBytes/sec |
Initiate Wide Negotiation | Yes (Enabled) |
Send Start Unit Command | No (Disabled) |
|
|
|
|
|
|
|
|
Advanced Host Adapter Settings | Default |
|
|
Plug and Play SCAM Support | Disabled |
Host Adapter BIOS | Enabled |
Support Removable Disks Under BIOS as Fixed Disks2 | Boot only |
Extended BIOS Translation for DOS Drives >1 GByte2 | Enabled |
Display | Enabled |
Multiple LUN Support | Disabled |
Support for Ultra SCSI Speed | Disabled |
1.Setting is valid only if multiple LUN Support is enabled.
2.Settings are valid only if host adapter BIOS is enabled.
Basic Host Adapter Settings
The basic host adapter settings are the SCSISelect settings most likely to require any modification.
nHost Adapter SCSI ID - This option sets the host adapter’s SCSI ID. The default setting is SCSI ID 7, which give the
Chapter 6 SCSI Setup and Configurations 71
