ADIC Version 5.0 manual Install VolServ

Installing VolServ

Install VolServ

Step 1. At the command line, enter the following command to begin the VolServ install script:

#/usr/tmp/volserv/vs_install

Step 2. The ADIC copyright license and the date the distribution CD was created displays as shown below:

Copyright 1992-2001 by ADIC, Inc. All rights reserved. No part of this work may be reproduced or transmitted in any form or by an means, electronic or mechanical, including photocopying and recording, or by any information storage or retrieval system, except as may be expressly permitted by the 17 U.S.C. section 101, et. seq., or in writing by ADIC, Inc.

CREATED ON <date stamp>

Step 3. To answer the script questions, use the table under “System Parameters Checklist” on page 1-6.

This installation will allow you to install multiple software packages. If you elect not to install something, then the installation will move on to the next package. The following software packages are contained in this installation:

-ADIC VolServ 5.0.0

-ADIC VolServ API 5.0.0

Do you wish to continue (<y> or n) ? y

------------------------------------------------------------------

Locating user commands…done.

------------------------------------------------------------------

Is media device location local (<y> or n) ? n

Enter hostname of remote device < >: hostname

Is hostname your intended response (<y> or n)? y

2-8 Installation Procedures 601351 Rev A