ADIC Version 5.0 manual Edit the /kernel/drv/sgen.conf file as shown Below, Window

Installing VolServ

Step 6. Edit the /kernel/drv/sgen.conf file as shown

below.

-----------------------------------------

name="sgen" class="scsi" target=0 lun=0; name="sgen" class="scsi" target=1 lun=0; name="sgen" class="scsi" target=2 lun=0; name="sgen" class="scsi" target=3 lun=0; name="sgen" class="scsi" target=4 lun=0; name="sgen" class="scsi" target=5 lun=0; name="sgen" class="scsi" target=6 lun=0; name="sgen" class="scsi" target=7 lun=0; #name="sgen" class="scsi" target=8 lun=0; #name="sgen" class="scsi" target=9 lun=0; #name="sgen" class="scsi" target=10 lun=0; #name="sgen" class="scsi" target=11 lun=0; #name="sgen" class="scsi" target=12 lun=0; #name="sgen" class="scsi" target=13 lun=0; #name="sgen" class="scsi" target=14 lun=0; #name="sgen" class="scsi" target=15 lun=0;

device-type-config-list="changer"; inquiry-config-list= "ADIC","*";

-----------------------------------------

The lines beginning with a # are comments. The lines can be un-commented out but the line corresponding to the known target ID of the connected SCSI library MUST NOT be commented out.

Additionally, the lines

device-type-config-list="changer"; and inquiry-config-list= "ADIC","*"; MUST be added to

this file to support ADIC Media Changers (libraries).

Step 7.	Access an OK prompt by simultaneously pressing
	the STOP key and the A key from a terminal
	window.

Post Installation Tasks

601351 Rev A Post Installation Tasks 3-11