ADIC Version 5.0 manual Configuring Scsi Device Nodes, SGI/IRIX Host

Installing VolServ

Configuring

SCSI Device

Nodes

SGI/IRIX Host

Note

These steps are only required when attaching a

SCSI-connected library.

If you are attaching a SCSI-connected library, use the following procedures.

Note

These instructions do not apply to a SCSI library that is to be controlled via the Scalar DLC network attachment.

To configure a SCSI device node to an IRIX host:

Step 1. Power-down the IRIX machine.

Step 2. Connect a properly terminated SCSI library.

Step 3. Power-up SCSI library.

Step 4. Wait for the library to finish power-up scanning.

Step 5. Power-up the IRIX host.

Step 6. Use the hinv utility to display all devices.

3-8 Post Installation Tasks 601351 Rev A