ADIC Version 5.0 manual Reboot the Solaris host machine using boot -r to, With two LTO drives

Installing VolServ

An OK prompt will appear on the desktop, not in a

CDE window.

	Step 8.	Reboot the Solaris host machine using boot -rto
		force re-configuration of hardware devices. This will
		create the device node required for the attached
		library.
		Be prepared to immediately do another STOP-A
		sequence as soon as the memory checks starts (this is
		when you see the cursor spin activity with the
		characters '\' '-' '/', etc. without moving position).
		This will abort the boot and return to the OK prompt.
	Step 9.	Enter probe-scsi-allat the OK prompt.
		The output will identify all SCSI connected devices.
		The following is an example output on a Scalar 10K
		with two LTO drives.:
ok probe-scsi-all
/pci@1f,0/pci5/scsi@2
<Name of controller card>
=========================
PCI Single Channel LVD HBA
SCSI-ID 7
--------------------------
Target 0
Unit 0	Removable Tape		IBM	ULTRIUM-TD1	16E0
Target 1
Unit 0	Removable Tape		IBM	ULTRIUM-TD1	16E0
Target 6
Unit 0	Removable Device type 8		ADIC Scalar 10K		120A

ok

Step 10. At the OK prompt, enter boot to reboot the system.

3-12 Post Installation Tasks 601351 Rev A