Total Access 600 Series SHDSL IAD User Interface
Page 36
1 | Yes - only when TCP established |
| No - only when TCP not established |
| Ignore - ignore TCP flags |
>Ethernet
Use the 9 menu (Figure 11) to configure the Ethernet port on the Total Access 600.
Figure 11. Ethernet Menu
IP
This is used to set up the IP addresses for the LAN on the Total Access 600.
IP Address
The IP address assigned to the Total Access 600's Ethernet port is set here. This address must be unique within the network.
Subnet Mask
This is the IP network mask that is to be applied to the Total Access 600's Ethernet port.
Default Gateway
The default gateway is used by the Total Access 600 to send IP packets whose destination address is not found in the route table.
Total Access 600 Series User Manual | © 2002, ADTRAN, Inc. |
