Total Access 600 Series SHDSL IAD User Interface Guide/64200683L1-31B

Page 42

• Route/Force IP

When set to YES, the Total Access 600 will force the PPP peer to use the IP address in the LOCAL IP for this profile as its WAN IP address. Normally this is set in the NO (def) position.

RIP

The RIP parameters can be adjusted from their defaults under this menu.

• Mode

The Total Access 600 performs RIP over the WAN connection when this is set to ON (def).

• Protocol

The Total Access 600 performs version 1, V1 (def), or version 2, V2, of RIP on this WAN connection.

• Method

 

SPLIT HORIZON

Only routes not learned on the WAN connection

 

are advertised.

POISON REVERSE￿

All routes are advertised, including routes learned

5*￿%6

from the WAN connection. These routes are poi-

 

soned.

NONE

• Direction

TX AND RX￿5*￿%6

All routes are advertised, including routes learned from the WAN connection. No attempt is made to poison these routes.

RIP advertisements are transmitted and listened to on the WAN connection.

TX ONLY

RIP advertisements are transmitted and not listened

 

to.

RX ONLY￿

RIP advertisements are listened to but not trans-

 

mitted.

• Triggered

When set to YES, only IP RIP updates are sent when the routing table has changed and learned routes are not "aged." When set to NO (def), updates are sent periodically.

• Retain

When this Connection List entry is disconnected and this parameter is set to YES, all routes learned from this WAN connection are retained and their routing interface is set to idle.

PPP

The Total Access 600 supports the IETF standards for the Point-to-Point Protocol. The PPP state machine running in the Total Access 600 can be fine-tuned to support many applications that can be employed. The configurable items under this menu can be changed from their default values for special cases.

VJ Compression

When this item is set to ON, the Total Access 600 will perform TCP/IP header compression known as Van Jacobson compression to the PPP peer.

Total Access 600 Series User Manual

© 2002, ADTRAN, Inc.

Page 42
Image 42
ADTRAN 600 Series user manual Only routes not learned on the WAN connection