ADTRAN 600 Series user manual Use this menu to enable RIP on the LAN interface, MAC Address

Total Access 600 Series SHDSL IAD User Interface Guide/64200683L1-31B Page 37

RIP

Use this menu to enable RIP on the LAN interface.

MODE

PROTOCOL

METHOD

NONE

SPLIT HORIZON￿

POISON REVERSE 5*￿%6

DIRECTION

TX AND RX 5*￿%6

TX ONLY￿

RX ONLY

V2 SECRET

Proxy ARP

Enables or disables RIP.

Specifies the RIP protocol. Choices are V1 (def) (which is RIP version 1) or V2 (RIP version 2).

Specifies the way the RIP protocol sends out its advertisements. Choices are given below.

All routes in the router table are advertised with no modification of the metrics.

Only routes not learned from this circuit are advertised.

All routes are advertised, but the routes learned from this port are “poisoned” with an infinite metric.

Allows the direction at which RIP advertise- ments are sent and listened to be specified.

RIP advertisements are periodically transmitted and are listened to on this port.

RIP advertisements are periodically transmitted but are not listened to on this port.

RIP advertisements are not transmitted on this port, but are listened.

Enter the secret used by RIP version 2 here.

This feature allows the network portion of a group of addresses to be shared among several physical network segments. The ARP protocol provides a way for devices to create a mapping between physical addresses and logical IP addresses. Proxy ARP makes use of this mapping feature by instructing a router to answer ARP requests as a "proxy" for the IP addresses behind one of its ports. The device which sent the ARP request will then correctly assume that it can reach the requested IP address by sending packets to the physical address that was returned. This technique effectively hides the fact that a network has been (further) subnetted. If this option is set to ;￿￿, when an ARP request is received on the Ethernet port the address is looked up in the IP routing table. If the forwarding port is not on the Ethernet port and the route is not the default route, the Total Access 600 will answer the request with its own hardware address.

MAC Address

This is a read-only MAC address programmed at ADTRAN.

© 2002, ADTRAN, Inc. Total Access 600 Series User Manual