Total Access 600 Series SHDSL IAD User Interface
RFC1483 IP
Use this selection to support IP on this PVC. (These settings only take effect when RFC1483 is the selected protocol.)
Active
This selection enables IP on this PVC.
Far - End IP Address
This is the address of the NEXT hop router on this interface.
IP netmask
This is the network mask used for this interface.
Local IP Address
This is the IP address for this PVC.
NAT
Use this menu to set up and use Network Address Translation on this interface.
NETWORK ADDRESS PORT TRANSLATION
PUBLIC IP ADDRESS MODE
TRANSLATION TABLE
PUBLIC ADDRESS
MODE
PROTOCOL
PUBLIC PORT MODE
By enabling port translation, IP packets are modified as they pass through this interface. During transmis- sion, private addresses are translated into a single public (NAPT) IP address. Incoming packets are translated from the public to private address based on the protocol port numbers. Once enabled, you must set up NAT for use.
The port translation requires at least a single real IP address for translating. This value can use the IP as- signed to the interface (or assigned via layer 2 proto- col like PPP), obtained using DHCP client, or statically specified on this menu. If the address cannot be learned, then it must be specified in order for the translation to work.
Add translation entries to "fine tune" special proto- cols or specify private addresses.
The public IP address used for this translation entry can be the NAPT IP address assigned to the link or can be specified. You specify an address to direct packets with certain protocols to different servers.
The upper layer protocol that is to be monitored for translation. For TCP and UDP, a port number must also be specified.
The public destination port associated with this entry can be specified to add more control over certain types of traffic. The default, ;1, covers all port types.
© 2002, ADTRAN, Inc. | Total Access 600 Series User Manual |
