ADTRAN ADT-1234POE manual NetVanta 1224ST Rear Panel Design, Gigabit Ethernet Interfaces/SFP Slots

NetVanta 1000/1000R Series Hardware Installation Guide Physical Descriptions

NetVanta 1224ST Front Panel Features

10/100BaseT Ethernet Interfaces

The NetVanta 1224STs contain 24 10/100BaseT Ethernet interfaces (RJ-45). These interfaces are consecutively numbered 1 through 24, from left to right, with the numbers screened directly above each port. Status LEDs for each of these interfaces are located directly over these numbers.

The NetVanta 1224ST PoE also has green and red PoE status LEDs located in the upper left and upper right corners (respectively) of each Ethernet connector.

Gigabit Ethernet Interfaces/SFP Slots

The NetVanta 1224STs also contain two Gigabit Ethernet interfaces that provide two fixed RJ-45 connectors and two standard SFP slots for fiber connectivity. (Use either the RJ-45 connectors or the SFP slots. The fiber slots have precedence.) These interfaces are labeled G1 and G2, and their status LEDs (also labeled G1 and G2) are located to the left of RJ-45 port 1, above the STAT LED.

Status LED

The STAT LED, which indicates the unit’s status, is located to the lower left of RJ-45 port 1.

Figure 4. NetVanta 1224ST Front Panel Layout

Figure 5. NetVanta 1224ST PoE Front Panel Layout

NetVanta 1224ST Rear Panel Design

The NetVanta 1224ST and NetVanta 1224ST PoE rear panel is shown below. Refer to Appendix A on page 67 for pinouts.

Figure 6. NetVanta 1224ST and NetVanta 1224ST PoE Rear Panel Layout

61200500L1-34N Copyright © 2008 ADTRAN, Inc. 19