Unit Installation

NetVanta 1000/1000R Series Hardware Installation Guide

 

 

Instructions for Installing the DIMs

Step

Action

1Remove power from the unit.

2If the NIM is already in the NetVanta chassis, remove all cables, release the pins at both edges of the NIM front panel and slide the module out of the chassis.

3Carefully align the P1 connector on the NIM with the J1 connector on the DIM. Using only fingertip pressure so that neither circuit board bends or flexes, ensure that the connectors are firmly seated. Secure the DIM to the NIM using the screws and standoff posts supplied. See Figure 38.

4Slide the NIM with the DIM attached into the NetVanta chassis, continuing with the normal NIM installation (refer to Instructions for Installing the NIMs on page 59).

Figure 38. Installing DIMs

58

Copyright © 2008 ADTRAN, Inc.

61200500L1-34N

Page 58
Image 58
ADTRAN ADT-1234POE manual Instructions for Installing the DIMs Step Action, Installing DIMs