57 Appendix 8
Multiple Monitors
Multiple Monitors supports from two to six touch screen displays for one
system. The PenMount drivers for Windows 2000/XP support Multiple
Monitors. This function supports from two to six touch screen displays
for one system. Each monitor requires its own PenMount touch screen
control board, either installed inside the display or in a central unit. The
PenMount control boards must be connected to the computer COM ports
via the RS-232 interface. Driver installation procedures are the same as
for a single monitor. Multiple Monitors supports the following modes:
Windows Extend Monitor Function
Matrox DualHead Multi-Screen Function
nVidia nView Function
Enable the multiple display function as follows:
1. Check the Enable Multiple Monitor Support box; then click
Map Touch Screens to assign touch controllers to displays.
NOTE: The Multiple Monitors function is for use with
multiple displays only. Do not use this function
if you have only one touch screen display.
Please note once you turn on this function the
Rotating function is disabled.