3.5 | Chipset Features Setup | 40 |
| 3.5.1 SDRAM (CAS Lat / | 40 |
| 3.5.2 DRAM Speculative Read | 41 |
| 3.5.3 16 Bit I/O Recovery Time / 8 Bit I/O Recovery Time | 41 |
| 3.5.4 Memory Hole At | 41 |
3.6 | Power Management Setup | 42 |
| 3.6.1 Power Management | 42 |
| 3.6.2 PM Control by APM | 42 |
| 3.6.3 Video Off Method | 43 |
| 3.6.4 MODEM Use IRQ | 43 |
| 3.6.5 HDD Power Down | 43 |
| 3.6.6 ZZ Active in Suspend | 43 |
| 3.6.7 PCI/VGA | 43 |
| 3.6.8 | 44 |
| 3.6.9 PowerOn by Ring | 44 |
| 3.6.10 PowerOn by Alarm | 44 |
3.7 PnP PCI Configuration Setup | 45 | |
| 3.7.1 | 45 |
| 3.7.2 | 46 |
3.8 | Load BIOS Defaults | 46 |
3.9 | Load Setup Defaults | 46 |
3.10 | Integrated Peripherals | 47 |
| 3.10.1 IDE HDD Block Mode | 47 |
| 3.10.2 IDE Primary Master/Slave PIO/UDMA Mode, |
|
| IDE Secondary Master/Slave PIO/UDMA Mode (Auto) 47 | |
| 3.10.3 | 48 |
| 3.10.4 Onboard FDC Controller | 48 |
| 3.10.5 Onboard Serial Port 1 (3F8H/IRQ4) | 48 |
| 3.10.6 Onboard Serial Port 2 (2F8H/IRQ3) | 48 |
| 3.10.7 UART Mode Select | 48 |
| 3.10.8 UART2 Duplex Mode | 48 |
| 3.10.9 RxD, TxD Active | 48 |
| 3.10.10 Onboard Parallel Port (378H/IRQ7) | 49 |
| 3.10.11 Parallel Port Mode (ECP + EPP) | 49 |
| 3.10.12 ECP Mode Use DMA | 49 |
3.11 | Password Setting | 49 |
3.12 IDE HDD Auto Detection | 50 | |
3.13 Save & Exit Setup | 50 | |
3.14 | Exit Without Saving | 50 |