Assembling of the SAB Cab | AEG ARE I2 specs

Manual

Page 33 / 33- Revision 01

ARE I2 / RS 232 – Installation Guide

12.3Assembling of the SAB Cab

AEG

Identifikationssysteme GmbH

Söflinger Straße 100 D-89077 Ulm

Tel. ++49(0)731-933-1340/1877 Fax ++49(0)731-933-1855e-mail: info@AEGID.de

Image 33

AEG ARE I2 manual Assembling of the SAB Cab

Contents

Page Introduction System Overview START-UP Procedure Installation Appendix 4 / 33- Revision System Overview Introduction Start-up Procedure Mounting of the Housing InstallationAssemblage of the Line Connectors Grounding of the Reader Assembling of the Cable Pipe Allowed Diameter of the Used Cables Arranged Parts for Mounting Mounting of the Power Supply Cable Are Plug in of the SAB Cab Final Assembly of the Cable Pipe RS232 Using the Service Cable ID Power Supply Using the Power Supply and Data Cable ID Are Visual Signal Lamps General Settings of the Reader / Most Important Parameters CID Suppression of ID Codes Error Codes NID- Failure Protection CN Suppression of No Reads CID=1 BD- Baudrate EC- Echo TOR Maximum Reading Time VS- Show ParameterVsave Save Parameter Operating Modes of the Reader Mode 2 Triggered by an Software Command 22 / 33- Revision Settings of the Reader / Most Used Parameters ReadOnly-Transponder Basic Data Exchange Process4 R / W -Transponder Standard Read Process / Serial Number of the Transponder GT Writing Process WD Selective Read RD Response of the transponder was not readable Continuous operation Operating Mode 0 Continuous Reading 27 / 33- Revision General Instructions Instructions Special Instructions for Using a Read / Write System Hotline Reference DocumentationRevisions Appendix Best Orientation for an F-Type -Reader Best Orientation for an L-Type -Reader Assembling of the SAB Cab