Manual
Page 13 / 33- Revision 01
ARE I2 / RS 232 – Installation Guide
4.3.8 Using the Power Supply and Data Cable ID 70212
Using the Power Supply and Data Cable, no special assembly work inside of the SAB Cab has be done by the customer. After making the link to a power supply and to the connector block of Serial Data Port, the reader is ready to work.
power supply: | brown = | + 9 ...30 Volt |
| white = | Ground |
serial Interface: | green = | RxD ( reader receives data‘s ) |
RS 232 | yellow = | TxD ( reader sends data‘s ) |
| grey = | ground |
4.4Power Supply
The device is designed for DC Current with an voltage in the range between 9. to .30VDC. The minimum power of the power supply is 1.2 Watt. There no need to use special cable to supply the device.
Attention!
The minimum voltage at the at the readers input mustn’t be lower then 9V.
AEG
Identifikationssysteme GmbH
Söflinger Straße 100
Tel.
