4 / 33- Revision | AEG ARE I2 guide

Manual

Page 4 / 33- Revision 01

ARE I2 / RS 232 – Installation Guide

AEG

Identifikationssysteme GmbH

Söflinger Straße 100 D-89077 Ulm

Tel. ++49(0)731-933-1340/1877 Fax ++49(0)731-933-1855e-mail: info@AEGID.de

Image 4

AEG ARE I2 manual 4 / 33- Revision

Contents

Page Introduction System Overview START-UP Procedure Installation Appendix 4 / 33- Revision Introduction System Overview Start-up Procedure Installation Mounting of the HousingAssemblage of the Line Connectors Grounding of the Reader Allowed Diameter of the Used Cables Assembling of the Cable Pipe Mounting of the Power Supply Cable Arranged Parts for Mounting Are Final Assembly of the Cable Pipe Plug in of the SAB Cab Using the Service Cable ID RS232 Using the Power Supply and Data Cable ID Power Supply Visual Signal Lamps Are Settings of the Reader / Most Important Parameters General Error Codes CID Suppression of ID Codes CN Suppression of No Reads NID- Failure Protection CID=1 EC- Echo BD- Baudrate VS- Show Parameter TOR Maximum Reading TimeVsave Save Parameter Mode 2 Triggered by an Software Command Operating Modes of the Reader Settings of the Reader / Most Used Parameters 22 / 33- Revision Basic Data Exchange Process ReadOnly-Transponder4 R / W -Transponder Standard Read Process / Serial Number of the Transponder GT Selective Read RD Writing Process WD Response of the transponder was not readable Operating Mode 0 Continuous Reading Continuous operation 27 / 33- Revision Instructions General Instructions Special Instructions for Using a Read / Write System Reference Documentation HotlineRevisions Appendix Best Orientation for an F-Type -Reader Best Orientation for an L-Type -Reader Assembling of the SAB Cab