Agilent Technologies E3632A manual Calibration Errors

Chapter 5 Error Messages

Calibration Errors

	Calibration Errors
	The following errors indicate failures that may occur during a calibration.
	Refer to the Service Guide for more information.
701	Cal security disabled by jumper
	The calibration security feature has been disabled with a jumper inside the
	power supply. When applicable, this error will occur at power-on to warn you
	that the power supply is unsecured.
702	Cal secured
	The power supply is secured against calibration.
703	Invalid secure code
	An invalid calibration security code was received when attempting to unsecure
	or secure the power supply. You must use the same security code to unsecure
	the power supply as was used to secure it, and vice versa. The security code
	may contain up to 12 alphanumeric characters. The first character must be a
	letter.
704	Secure code too long
	A security code was received which contained more than 12 characters.
705	Cal aborted
	A calibration in progress is aborted when you press any front-panel key, send
	a device clear, or change the local/remote state of the instrument.
708	Cal output disabled
	Calibration is aborted by sending OUTP OFF command during calibrating a
	output.
712	Bad DAC cal data
	The specified DAC calibration values (CAL:VOLT or CAL:CURR) are out of
	range. Note that the new calibration constants are not stored in the non-volatile
	memory.
713	Bad readback cal data
	The specified readback calibration values (CAL:VOLT or CAL:CURR) are out

of range. Note that the new calibration constants are not stored in the non- volatile memory.

129

5