Aiwa XM-M25 manual Press TUNER/BAND repeatedly to select the desired band m

	SHIFT
1	BANDI
2
	MODE
4* DIR/	TUNER
PRESET

1 Press TUNER/BAND repeatedly to select the desired band.

m

When TUNEFUBAND is pressed while the power is off, the previously tuned station will be played (Direct Play Function).

To select a band with the remote control

Press BANDIMODE TUNER repeatedly.

2 Press 4+ DOWN or W UP to select a station.

Each time the button is pressed, the frequency changes. When a station is received, “TUNE is displayed for 2 seconds. During FM stereo reception, “[IIUDII]”is displayed.

To search for a station quickly (Auto Search)

Keep + DOWN or - UP pressed until the frequency starts to change rapidly. After tuning into a station, the search stops.

To stop the Auto Search manually, press + DOWN or - UP.

●The Auto Search may not stop at stations with very weak signals.

When an FM stereo broadcast contains noise

Press BAND/MODE TUNER while pressing SHIFT on the remote control so that “MONO appears on the display.

Noise is reduced, although reception is monaural.

To restore stereo reception, press these buttons so that “MONO disappears.

MONO

To change the AM tuning interval

The default setting of the AM tuning interval is 10 kHz/step. If you use this unit in an area where the frequency allocation system is 9 kHz/step, change the tuning interval.

Press POWER while pressing +~ DIFUPRESET during power on.

To reset the interval, repeat this procedure.

m

When the AM tuning interval is changed, all preset stations are cleared. The preset stations have to be set again.

7 ENGLISH