Aiwa XM-M25 manual FOCKj IX NtW FXPCM3E TIE@ Appliance to Rain $X3 MUETt,RE, Electric Shock

““.

%ARM#w” .. ~~

l-clRmeE”THE Fi!3K””aFFf@ cmEuxmifcl

&fOCKj IX) NtW FXPCM3E TIE@ APPLIANCE TO.

““RAIN $X3 MUETt,RE;	:
A ~	I,“. e
		A
RISK OF ELECTRIC SHOCK
	DO NOT OPEN		●

“CAUTION:TO REDUCE THE RISK OF

ELECTRIC SHOCK,

DO NOT REMOVE COVER (OR BACK). NO USER-SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.”

Read the Operating Instructions carefully and completely before operating the unit. Be sure to keep the Operating Instructions for future reference. All warnings and cautions in the Operating in- structions and on the unit should be strictly followed, as well as the safety suggestions below.

Installation

1Water and moisture — Do not use this unit near water, such as near a bathtub, washbowl, swimming pool, or the like.

2Heat — Do not use this unit near sources of heat, including heating vents, stoves, or other appliances that generate heat. It also should not be placed in temperatures less than 5°C (41 “F)or greater than 35°C (95”F).

3Mounting surface — Place the unit on a flat, even surface.

4Ventilation — The unit should be situated with adequate space around it so that proper heat ventilation is assured. Allow 10 cm (4 in.) clearance from the rear and the top of the unit, and 5 cm (2 in.) from the each side.

-Do not place the unit on a bed, rug, or similar surface that may block the ventilation openings.

-Do not install the unit in a bookcase, cabinet, or airtight rack where ventilation may be impeded.

5Objects and liquid entry — Take care that objects or liquids do not get inside the unit through the ventilation openings.

6Carts and stands — When placed or mounted on a stand or cart, the unit should be moved with care.

Quickstops,excessive force, and	m	“3
uneven surfaces may cause the		AL*
unit or cart to overturn or fall.

7Condensation — Moisture may form on the CD pickup lens when:

-The unit is moved from a cold spot to a warm spot

-The heating system has just been turned on

-The unit is used in a very humid room

-The unit is cooled by an air conditioner

When this unit has condensation inside, it may not function normally. Should this occur, leave the unit for a few hours, then try to operate again.

8Wall or ceiling mounting — The unit should not be mounted on a wall or c~ling, unless specified in the Operating instruc- tions.

Electric Power

1Power sources — Connect this unit only to power sources specified in the Operating Instructions, and as marked on the unit.

2Polarization —As a safety feature, some units are equipped with polarized AC power plugs which can only be inserted one way into a power outlet. If it is difficult or impossible to insert the AC power plug into an outlet, turn the plug over and try again. If it still does not easily insert into the outlet, please call a qualified service technician to service or replace the outlet. To avoid defeating the safety feature of the polarized

plug, do not force it into a power outlet.

3AC power cord

-When disconnecting the AC power cord, pull out by the AC power plug. Do not pull the cord itself.

-Never handle the AC power plug with wet hands, as this could result in fire or shock.

-Power cord should be routed to avoid being severely bent, pinched, or walked upon. Pay particular attention to the cord from the unit to the power socket.

-Avoid overloading AC power plugs and extension cords beyond their capacity, as this could result in fire or shock.

1 ENGLISH