ASSEMBLY

ASSEMBLY

CONTROL RODS - PULL TYPE

Attach the two level-lift control rods to the lower lugs on tongue and to lugs on the rear axle tube using pins, washers and cotter pins. Note: The adjusting nuts on control rods should be to rear of machine and should always be adjusted with equal tension on both rods. Figure Asm-R-0289 & Asm-R-0290.

DRIVELINE CLAMP CONE YOKE

Loosen the yoke clamp cone with a 11/16” (17mm) wrench and remove the cone from yoke. Slide yoke onto the shaft and align hole for clamping cone with annular groove of gearbox shaft. Reinstall cone and tighten (75 lb-ft torque). Push and pull the driveline to ensure it is securely attached to the shaft. Regularly check the driveline yoke to ensure a tight connection. To remove the yoke, remove the connecting cone and pull yoke off the shaft. If the cone cannot be easily removed by hand, drive it out from the other side using a hammer and punch.

NOTE: The clamping cone is serviced only as a complete assembly. Do not attempt to disassemble the clamping cone.

WHEELS

Install the Wheels on the Wheel Hubs.

Note: If Laminated Tires are used, place the flat side of the Lug Nut against the Wheel.

Note: the direction of travel and curvature of rubber segments in tire and install as shown in FIGURE Asm-R-0127.

RX96 03/09

Assembly Section 3-6

© 2009 Alamo Group Inc.

Page 90
Image 90
Alamo RX96 manual Control Rods Pull Type, Driveline Clamp Cone Yoke, Wheels