ASSEMBLY

HYDRAULIC OR MANUAL LIFT - PULL & OFFSET TYPE

Attach the Spring Assembly option (Figure ASM-R-0111)to the lug on the mower deck behind the Center Gearbox. Retain using 1 x 2-3/4 bolt and locknut. Install the Hydraulic Cylinder (Figure ASM-R-0111)or the manual Ratchet Lift Screw 1"x 2-3/4" (Figure ASM-R-0112)between the Axle Center Lug and the Lug directly behind the Center Gearbox. Tighten all Bolts securely.

ASSEMBLY

CASTER WHEEL ASSEMBLY (Lift-Type)

Standard 4:00 x 8 caster wheel assembly

Install the two axle arm weldments (1) on the rear axle so that the Main Beam or tube of weldment is angled down toward ground. Space axle arm weldment (1) so wheels will be at the desired row spacing. Install all four bolts (3) in each axle arm weldments and tighten bolts evenly so that space between upper and lower clamp faces remain approximately the same. Figure Asm-R-0303

RX96 03/09

Assembly Section 3-12

© 2009 Alamo Group Inc.

Page 96
Image 96
Alamo RX96 manual Hydraulic or Manual Lift Pull & Offset Type, Caster Wheel Assembly Lift-Type