Alcatel-Lucent 6300-24 manual Connecting to a Power Source

Connecting to a Power Source 3

3.If installing a single switch only, go to “Connecting to a Power Source” at the end of this chapter.

4.If installing multiple switches, attach four adhesive feet to each one. Place each device squarely on top of the one below, in any order.

Installing an Optional SFP Transceiver into the Switch

1 1

2 2

1

2

3 3

4 4

3

4

		100		0
1000=Y
5	5	ellow1 00=Green
		7	7		100=Green10/100=Yellowellow
5									10=Flash
		7		9	9	1111					ing		Green
				9				1313
						11				1515
								13				1717
6	6									15				1919
												17
6		8	8	1010										19
		8				1212
				10				1414
						12				1616
		ellow1000=Green						14				18		2020
1000=Y										16		1818
					100=G			10/100=Y						20
							reen			ellow
									10=Flashing				Green

2121 21

222 22

2323 23

2424 24

Link/Link/

ActLinkAct

FDXFDX Act

Link/Link/

ActLiAnckt

FDXFDX Act

Power

Power

Diag

Diag

BPSRPU RPU

O
mniiStt
	acck
6300-
	24

Console onsole

Figure 3-5. Inserting an SFP Transceiver into a Slot

To install an SFP transceiver, do the following:

1.Consider network and cabling requirements to select an appropriate SFP transceiver type.

2.Insert the transceiver with the optical connector facing outward and the slot connector facing down. Note that SFP transceivers are keyed so they can only be installed in one orientation.

3.Slide the SFP transceiver into the slot until it clicks into place.

Note: SFP transceivers are hot-swappable. The switch does not need to be powered off before installing or removing a transceiver. However, always first disconnect the network cable before removing a transceiver.

Connecting to a Power Source

To connect a device to a power source:

1.Insert the power cable plug directly into the receptacle located at the back of the device.

3-5