Installing a Device in the NEC Modular Bay Slot
Use the following steps to install a device in the NEC Modular Bay slot.
1.Use the Phoenix BaySwap utility or power off the system.
2.Remove the Modular Bay device or
3.Align the device in the NEC Modular Bay slot and push it in until it fits securely into the bay. Make sure the latch secures the device.
4.Press the Power button to power on or resume operation.
Removing a Device from the NEC VersaBay IV Slot
Use the following steps to remove a device from the NEC VersaBay IV slot.
1.Use the Phoenix BaySwap utility or power off the system.
2.Close the LCD panel and turn the system over.
3.Locate the NEC VersaBay IV release latch (see the following figure).
Locating the NEC VersaBay IV release latch
A – NEC VersaBay IV Release Latch | B – NEC VersaBay IV Device |
4. Slide the latch toward the back of the system and hold it.
