NEC L320 manual Security Menu, System Security Setup

BootUp Message — Enabled allows a boot message to be displayed while the system boots.

Save to Disk Warning — When set to Disabled, no Save-to-Disk warning is displayed if the SAVE2DSK.BIN file does not exist.

Summary Screen — When set to Enabled, system configuration information is displayed on the screen during boot.

Silent Boot — When set to Enabled, the NEC logo screen is displayed during system boot. When set to Disabled, the Power-On Self-Test (POST) information is displayed during system boot. When set to Black, the screen is black until the system has booted.

Wireless Device — Enabled allows a Wireless LAN device (if installed) to be used. Disabled prevents a wireless device from functioning. (This setting only appears on

Tsystems with a Wireless LAN device installed.)

I/O Device Configuration — Pressing the Enter key brings up a sub-menu with entries for enabling the serial port, infrared port, parallel port, and the diskette drive controller. The infrared (IR) port is disabled by default. See “IR Port” in Chapter 6 for information about using the IR port.

Security Menu

Use the Security menu to configure your system for protection against unauthorized access.

System Security Setup

Parameter	Default Setting	Alternate Setting(s)
Security Mode	Password	FingerPrint
Set Supervisor Password	Press Enter
Set User Password	Press Enter
Set Supervisor FingerPrint	Press Enter
Set User FingerPrint	Press Enter
Password on Boot	Disabled	Enabled
Fixed Disk Boot Sector	Normal	Write Protect
Diskette Access	Supervisor	User
Assign HDD Password	Press Enter
Internal HDD password	Disabled	Enabled

3-8 Using the BIOS Setup Utility