Alesis K2661 Entering Selection Criteria in the Multiple Object Selector, 13-39, Type/Range Mode

Basic Disk Mode

The Multiple Object Selector Page

Entering Selection Criteria in the Multiple Object Selector

This section describes the operation of the selection modes provided on the Multiple Object Selector page. These are accessed by scrolling the Select: parameter to different values, as pictured above.

Type/Range Mode

This mode lets you select objects based on their type, and on a particular range of object IDs.

Parameter		Possible Values	Function
Type		Sample, Keymap,	Sets the desired object type. The value All Types will select all of
		Effect, Program,	the other possible types.
		Setup, QABank,
		VelMap, PrsMap,
		IntTbl, Song, Table, All
		Types
Bank		000s, 100s, 200s,	Sets the desired bank. Changing this parameter causes the
		300s, 400s, 500s,	StartId and the EndId to be set to the limits of the chosen bank (for
		600s, 700s, 800s,	example, a value of 300s sets the StartId to 300 and the EndId to
		900s, All Banks	399). A value of All Banks sets the StartId to 0 and the EndId to
			999.
			The actual range used for selections when Toggle, Set, or Clear is
			pressed is taken from the setting of the StartId and EndId
			parameters. For example, if you set the Bank to 200s and then
			change the StartID to 300 and the EndID to 399, the 300s bank
			will be selected, not the 200s.
			The Bank parameter is used as a quick way to set up the ID range
			for an entire bank, or all banks.
StartID		0–999	Sets the specific starting ID of the selection range.
EndId		0–999	Sets the specific ending ID of the selection range.
Table 13-2	Object Selection by Type / Range

It is possible to set the EndId before the StartId. If this is the case, the selection range is empty.

13-39