Alesis K2661 specifications RecMode, 12-33

		Song Mode
		Song Mode: The MISC Page
Parameter	Range of Values	Default
Record Mode	Linear, Fixlen, Loop, Unloop, Auto	Linear
Play Mode	Linear, Loop, List, Chain	Loop
Key Wait	On, Off	Off
Locate	-25:2 – 999:4	1:1
Auto In	1:1 – 999:4	1:1
Auto Out	1:1 – 2500:	1:1
Input Quantize	Off, 1% – 100%	Off
Grid	1/1 – 1/384	1/8
Swing	-99% – 125%	0%
Sync	Both, Xmit, Recv, Off	Off
Clock	Int, Ext	Int
Tempo	Auto, Fixed	Auto
Countoff	Off, 1, 2, 3	1
Click	Off, Rec, On, Cnt	Rec
Click Channel	1 – 16	16
Click Program	1 – 999	198
Click Key	C-1 – G9	C4
Click Velocity	1 – 127	100

The top line displays the amount of free event space and the current sequencer state, which is one of the following: STOPPED, PLAYING, REC READY, RECORDING, KEY WAIT, or EXT. CLOCK.

RecMode

When recording the first track of a new song, you will be able to record as if you had an endless length of “tape” no matter what the recording mode is set to.

When you record the first track, all recording modes operate the same way. This is because until you define the length of a new song, its End point is the default setting of Bar 8001, the maximum amount of Bars in a song. The End point is referenced and modified in different ways depending on the RecMode.

The End point of a song is defined when:

1.The Stop button is pressed to end the recording of the first track. The new End point is aligned to the nearest downbeat of the (empty) Bar immediately following the last Bar you were recording when Stop was pressed.

2.Stop is pressed while recording any track past the previously set End point in Linear or UnLoop recording mode. Again, the new End point is aligned to the downbeat of the (empty) Bar immediately following the last Bar you were recording when Stop was pressed.

3.The AutoOut Bar and Beat is set past current End point, after recording in Auto RecMode, and when the first track is recorded in Auto RecMode, the AutoOut Bar and Beat becomes the End point.

12-33