Alliance Laundry Systems SVN255P, UVN255P , ,

Cod. G522433

Tilt system assembly 36

Adjustment of position detectors actuators (figure 44)

The actuators C are secured to the bases throug h slots

permitting their movement. To adjust their position:

 The machine must be in the rest position.

 Loosen mounting screws D of actuators C of position

detectors.

 Move completely the actuators to the washer’s outside

until the microswitch disconnection «clic k» is heard. The

wheel support lever E will remain in horizontal position.

 Move the actuators C towards the position detectors until

the microswitch connection «click» is heard and secure

them in this position. (The contacts change of position is

easily heard).

 The actuator must move the lever wheel from the position

detector upwards (refer to figure).

 More information in the complementary schemat ic of

TILT supplement. The schematic shows the machine in

rest position.

 Once the position detectors actuators adjustment

continue removing the transport restraints, assembling

the covers and installing the machine power supplies

(section 2.5).

fig. 36

The arrow indicates the front of the machine.

 Position the rear and front guards. They can be easily

identified as the corners are folded. The rear guard is

distinguished by the drain hose groove.

 Remove screws, washers and sleeves screwed in the

hinges A from the guards, secured to each of the four

bases. Put the sleeves in the holes at the guards corners.

Secure them using screws and washers. The sleeves

must permit the guards movement. Rectify supports

position if required, by loosing the mounting screws B

and move them in the appropriate direction.

 Engage the springs C between the base brackets and the

guards brackets (two springs for each bracket).

 Place the side guards between the side brackets and the

folded corners of the front and rear guards.

 Place them so that the holes match with the threaded

holes at the side brackets D. Secure them with screws

(M6x10).

ATTENTION!

Never start the machine up or use it until all the co vers

have been replaced and properly locked. fig. 37