PEM plug with connections indicated | Allied Telesis 9103, 9102

Connect the -48VDC office power supply to the 9101 PEM plug. Installing Power and Ground for the 9101

1.8.3 Connect the -48VDC office power supply to the 9101 PEM plug.

1.Loosen the screws.

2.Using cables colored as in Figure 1-12, strip each 1/4 in. (6.5 mm).

3.Insert each cable into its appropriate lug on the PEM plug. Use the figure below to determine the correct lugs.

FIGURE 1-129100 PEM plug with connections indicated

4.Tighten each screw.

5.Carefully dress and tie-wrap or tape the power and ground cables.

6.Ensure that fuses A and B have been removed from the 9100 PEM.

7.Plug the 9100 PEM plug into its connector on the faceplate of the unit. The PEM plug will only fit one way. Tabs on the front of the PEM plug prevent it from being inserted incorrectly.

Telesyn 9100 Installation Guide (Installation of Allied Telesyn 9100)

1-21

Image 25

Allied Telesis 9103, 9102 Connect the -48VDC office power supply to the 9101 PEM plug, PEM plug with connections indicated

Contents

Page Who Should Read This Guide? Reason for UpdateAbout this Guide Table of Contents Appendix Allied Telesyn 9100 Configuration Installation Overview for Selecting a Site for Following Procedures for the 9101, 9102, 2Site Requirements for Allied Telesyn 1 9101 Site Requirements 3Site Requirements for Allied Telesyn 9102 2 9102/9103 Site Requirements 9102/9103 Site Requirements Selecting a Site for 4Part Checklist for Setup Checklist5Customer Item Checklist 1 9101 Parts Included in Order 7Part Checklist for 6Part Checklist for2 9102 / 9103 Parts Included in Order Shelf Mounting Options 8Customer Item Checklist1 9101 Mounting Options 4Front mount option for Shelf Mounting Options Center Mounting Option 6Front Mount for 9102/3 2 9102/3 Mounting Options 7Mid-Mount for 9102/3 Attaching the Extension Brackets and Rear Brackets Overview Wall Mounting Option Installing the Wall Mount Allied Telesyn 9100 Installation SafetySafety Guidelines Electrostatic Discharge Safety Precautions While Working with Electricity Precautions and Conformance Standards Laser Safety Instructions Installing Power and Ground forPower and Grounding Cautions Connect Power and Ground Installing Power and Ground for Connect Power and Ground 129100 PEM plug with connections indicated Connect the -48VDC office power supply to the 9101 PEM plug Apply and Check Power DC Power Supply Connect to Power Source Single or Dual Apply and Check Power AC Power Supply Alarm Connections 9101 Optional Install the CFC12 Install Card Modules Install the SFP Module Install the Service Module Install Filler Plates FPF Configure Local Terminal or PC Option Default 9Default Asynchronous Port Settings Connect System Cables Service Modules with RJ21connectors SMs with Optical connectors SMs with RJ45 connectors13.4 GE4/FE2 Data Management Cable Mgmt Port on CFC12 Apply Power and Check Startup Sequence Page Check software load Check the configurationCheck management interfaces Allied Telesyn Contact Information Adding AC Power Module Glossary of Terms Appendix 1Registration Information for the Telesyn Telesyn 9100 Inventory Form