Install the Service Module Install Card Modules
1-25
Telesyn 9100 Installation Guide (Installation of Allied Telesyn 9100)
FIGURE 1-15 Detail of the card latch in Open Position (Card Below is Locked)
1.11.2 Install the Service Module
The Service Modules can be placed in any of slots 0, 1 and 2. It is recommended that the slots be filled in numer-
ical order (0, then 1, then 2).
1. Take the card from its antistatic container.
2. For insertion into slots 0 or 2, hold the card securely with component side down. For insertion into slot 1, hold
the card by its latches with component side up. (For any slot, the latch/label will go on the inside of the chas-
sis).
3. Press the release buttons on the inside of the latches and push the latches out.
4. While holding the card, slowly but firmly push the card into the slot until the latches begin to engage the lock-
ing rail.
5. Close the latches until the card locks into place.
1.11.3 Install the SFP Module
The Small Form Factor Pluggable module, which are inserted in the CFC12, can be ordered from your Allied
Telesyn representative. Some have a bail latch.