AT-MC601 and AT-MC602 Installation and User’s Guide
Hardware Features
The following sections describe these hardware features of the
AT-MC601 and AT-MC602 network extenders:
❑VDSL Line port
❑PSTN port
❑10/100 Mbps twisted pair Ethernet port
❑Status LEDs
❑Management port
❑Management cable
❑12V DC power supply input port
❑External AC/DC power adapter
Note
The AT-MC602 unit can only be installed in an AT-MCR12 chassis.
VDSL Line Port The VDSL Line port allows you to connect the AT-MC601 Subscriber unit to a telephone jack (wall outlet) and the AT-MC602 Provider unit to the inside phone line at the wiring closet. The two units need to be within 1,200 meters of each other in order for the port to operate properly. The port transmits voice data at a frequency of 8-10 KHz and Ethernet data at frequencies of 300 KHz to 8 MHz. This port features an RJ-11 connector.
Table 1 lists the RJ-11 port pinouts and their assignments.
| Table 1 VDSL - RJ-11 Port Pinouts |
| | |
Pin | | Assignment |
| | |
| | |
1 | | pass-through 6 |
| | |
2 | | pass-through 5 |
| | |
3 | | Ethernet and phone ring |
| | |
4 | | Ethernet and phone tip |
| | |
5 | | pass-through 2 |
| | |
6 | | pass-through 1 |
| | |
