OPE R A Ti o n
u s e r options
Lock
Indicator
Preset Keys Lock and Unlock
Preset Keys A through H can be locked in order to prevent storing, altering or erasing a program.
To lock the preset keys, press and hold the “I” Key until the oven beeps. Release the “I” key. The green indicator on the “I” key will illuminate. Oven Preset Keys A through H are now locked.
Note: Only the oven Preset keys A through H are affected by this
To unlock the preset keys, press and hold the
Cancel Key along with the “I” Key for two seconds until the “I” key light no longer illuminates. Release all keys. The oven preset keys are now unlocked.
Fahrenheit or Celsius Selection
With the control in the off mode,
press and hold the Up Arrow Key until the display shows the current selection. Press the up or down buttons to toggle between the two options. After each change the button must be released. The display must clear before the procedure can be repeated.
Preset
Lock
Control Panel Lock and Unlock
The control panel can be locked at any time in order to prevent inadvertent or accidental setting changes.
To lock the control panel, press and hold the
Up Arrow Key and then press the on/off Key. You will hear a brief beep and the panel lock indicator will illuminate. Release all keys.
The oven’s control panel is now locked.
Note: The control panel is now fully locked with the exception of the on/off Key and Arrow keys. You will be unable to turn the oven control off at this point.
To unlock the control panel, press and hold the Down Arrow Key and then press the on/off Key. You will hear three beeps and the panel lock indicator will extinguish. Release all keys. The panel is now unlocked and ready for normal use.
Beeper Volume Selection
With the control in the off mode, press and hold the Down Arrow Key until the display shows one of the 4 volume
levels (0 being off or the lowest, and
3 being the highest). After each change, the button must be released and the
display must clear before the procedure can be repeated to select a different volume level. Turn the unit on and then off again to store the desired set point.
TH/III installation/operation/service manual (11/12) | pg. 21 |
