Alto-Shaam 610ESG, 1218ESG, 1010ESG 714ESG, 530 x 325 x 65mm, 650 x 530 x 65mm, 18” x 26” x 1”

7•14ESG

[D] 4-3/8" (110mm)

27-7/8" (708mm)

[C]3-9/16"

(89mm)

Water Drain (Side Back)

49-13/16" (1265mm) 47-7/8" (1215mm)

44-7/16" (1128mm) 41-5/8" (1057mm)

12-13/16" 22-11/16"

(325mm) (575mm)

26-5/8" (675mm) 19-11/16"

(500mm) 17-1/4"

(438mm) 5-7/8" (148mm)

C	3/16"-
	Steam Vent (Top)
A	30
B
	(1865mm)
D

(766mm) 36-7/16" (925mm) 42" (1066mm) 5-1/8" (130mm)

Water Drain

(Bottom)

				7/16"	31-3/4"	7-9/16"		(650mm)
		2" (50mm)			(805mm)	(192mm)
				-				8-1/2" (216mm)
				73	33-1/8"	7-3/16"
			[D] 4-5/8" (116mm)
					(840mm)	(181mm)
	A = UNTREATED WATER
	B = TREATED WATER				DIMENSIONS: H x W x D
	C = ELECTRICAL
	D = GAS				EXTERIOR:
					42” x 49-13/16” x 44-7/16” (1066mm x 1265mm x 1128mm)
					EXTERIOR WITH RECESSED DOOR:
					42” x 53-13/16” x 44-7/16” (1066mm x 1367mm x 1128mm)
					INTERIOR:
					23-5/8” x 25-1/4” x 33-7/8” (600mm x 640mm x 860mm)
WATER REQUIREMENTS					WATER QUALITY MINIMUM STANDARDS
TWO (2) COLD WATER INLETS - DRINKING QUALITY					USING A WATER SUPPLY NOT MEETING ALTO-SHAAM’S MINIMUM
ONE (1) TREATED WATER INLET:			3/4” NPT* * Can manifold off of		WATER QUALITY STANDARDS WILL VOID THIS WARRANTY.
ONE (1) UNTREATED WATER INLET: 3/4” NPT*				one 3/4” line.	It is the responsibility of the purchaser to ensure that incoming water supply is
LINE PRESSURE:			30 to 90 psi	2.8 to 6.2 bar	compliant with the specifications listed through adequate treatment measures.
WATER DRAIN: 1-1/2” CONNECTION WITH A 2” MINIMUM					Installation of the CombiGuardTM Water Filtration System is recommended, but
AIR GAP INSTALLED AS CLOSE TO THE OVEN AS POSSIBLE					this system may not address all water quality issues present.
CLEARANCE REQUIREMENTS					Contaminant Inlet Water Requirements (untreated water)
LEFT	6” (152mm) RECOMMENDED SERVICE ACCESS: 18” (457mm)				Free Chlorine Less than 0.1 ppm (mg/L)
						Hardness Less than 3 gpg (52 ppm)
	20” (508mm) FROM HEAT PRODUCING EQUIPMENT
						Chloride Less than 30 ppm (mg/L)
RIGHT	4” (102mm) TOP: 20” (508mm) FOR AIR MOVEMENT
						pH 7.0 to 8.5
BACK	4” (102mm) BOTTOM: 5-1/8” (130mm) FOR LEGS					Alkalinity Less than 50 ppm (mg/L)
COUNTER-TOP INSTALLATIONS MUST MAINTAIN 4” (102mm) MINIMUM						Silica Less than 12 ppm (mg/L)
					Total Dissolved Solids (tds) Less than 60 ppm
CLEARANCE FROM COUNTER SURFACE
GAS REQUIREMENTS (TYPE MUST BE SPECIFIED ON ORDER)					INSTALLATION REQUIREMENTS
CONNECTED ENERGY LOAD:			91,000 Btu / hr (Natural Gas)		Oven must be installed level.
			88,000 Btu / hr (Propane)		Hood installation is required.
		HOOK-UP: 3/4” NPT
					Water supply shut-off valve and back-flow preventer.
MINIMUM CONNECTED PRESSURE: 5.5” W.C. (Natural Gas)
					Alternate burner orifice is required for installation sites at
			9” W.C. (Propane)
MAXIMUM CONNECTED PRESSURE:			14” W.C.		elevations of 2,000 feet (610m) above sea level.
ELECTRICAL (DEDICATED CIRCUIT REQUIRED)						7●14ESG		7●14ESG / sk
VOLTAGE	PHASE	CYCLE/HZ		AWG		AMPS	kW	AMPS	kW
110 – 120	1	50/60	NEMA 5-20P, 20A, 125V Plug, AWG 12			9.2	1.05	13.7	1.57
	OTHER VOLTAGES AVAILABLE: Range 200 – 415V – 1 or 3 ph, 50 or 60 Hz
WEIGHT			CAPACITY
NET	655 lb est	(297 kg)		FULL-SIZE PANS:	20” x 12” x 2-1/2”		Fourteen (14)
SHIP	785 lb	(356 kg)		GN 1/1:	530 x 325 x 65mm		Fourteen (14)
CRATE DIMENSIONS: (L x W x H)				GN 2/1:	650 x 530 x 65mm		Seven (7)
	45” x 53” x 48”		FULL-SIZE SHEET PANS:*		18” x 26” x 1”		Seven (7)
(1143 x 1346 x 1219mm)			ON WIRE SHELVES ONLY
					168 lb (76 kg) MAXIMUM
				VOLUME MAXIMUM: 105 quarts (133 liters)
			*ADDITIONAL WIRE SHELVES REQUIRED FOR MAXIMUM CAPACITY

COMBITOUCHTM ESG SERIES • GAS INSTALLATION MANUAL • 9.