Alto-Shaam 1010ESG, 1020ESG manual 1218ESG, 51-3/8” x 49-13/16” x 45-3/16” 1305mm x 1265mm x 1148mm

								12•18ESG
									45-3/16"
		7/8"-5 (148mm)		[D] 4-9/16" (116mm)					(1148mm)
						(506mm)	49-13/16" (1265mm)		(1077mm)
				[C] 3-9/16"
				[A,B] 4-3/8" (110mm)		19-15/16"			42-7/16"
				(89mm)		Water Drain	47-7/8" (1215mm)		12-13/16" 22-11/16"
						(Side Back)
		9/16"-26 (675mm) 11/16"-19 (500mm) 1/4"-17 (438mm)						9/16"-40 (1030mm) (1189mm)13/16"-46 (1305mm)3/8"-51	(325mm)	(575mm)
				C	Steam Vent	(1875mm)13/16"	(159mm)1/4"-6		(130mm)1/8"-5
			A		(Top)
			B
			D
									Water Drain
									(Bottom)
				[D] 4-5/8" (116mm)		-
						73
				2" (50mm)			31-3/4"		25-5/8"
		A = UNTREATED WATER					(805mm)		(650mm)
							33-1/8"	7-5/16"	8-1/2" (216mm)
		B = TREATED WATER
							(840mm)	(185mm)
		C = ELECTRICAL
					55-7/16"
		D = GAS
					(1407mm)		DIMENSIONS: H x W x D
							EXTERIOR:
							51-3/8” x 49-13/16” x 45-3/16” (1305mm x 1265mm x 1148mm)
							EXTERIOR WITH RECESSED DOOR:
							51-3/8” x 53-13/16” x 45-3/16” (1305mm x 1367mm x 1148mm)
							INTERIOR:
							33-7/8” x 25-1/4” x 33-7/8” (860mm x 640mm x 860mm)
WATER REQUIREMENTS							WATER QUALITY MINIMUM STANDARDS
TWO (2) COLD WATER INLETS - DRINKING QUALITY							USING A WATER SUPPLY NOT MEETING ALTO-SHAAM’S MINIMUM
ONE (1) TREATED WATER INLET:			3/4” NPT* * Can manifold off of				WATER QUALITY STANDARDS WILL VOID THIS WARRANTY.
ONE (1) UNTREATED WATER INLET: 3/4” NPT*					one 3/4” line.		It is the responsibility of the purchaser to ensure that incoming water supply is
LINE PRESSURE:			30 to 90 psi		2.8 to 6.2 bar		compliant with the specifications listed through adequate treatment measures.
WATER DRAIN: 1-1/2” CONNECTION WITH A 2” MINIMUM							Installation of the CombiGuardTM Water Filtration System is recommended, but
AIR GAP INSTALLED AS CLOSE TO THE OVEN AS POSSIBLE							this system may not address all water quality issues present.
CLEARANCE REQUIREMENTS							Contaminant Inlet Water Requirements (untreated water)
LEFT	6” (152mm) RECOMMENDED SERVICE ACCESS: 18” (457mm)						Free Chlorine Less than 0.1 ppm (mg/L)
								Hardness Less than 3 gpg (52 ppm)
	20” (508mm) FROM HEAT PRODUCING EQUIPMENT
								Chloride Less than 30 ppm (mg/L)
RIGHT	4” (102mm) TOP: 20” (508mm) FOR AIR MOVEMENT
									pH 7.0 to 8.5
BACK	4” (102mm) BOTTOM: 5-1/8” (130mm) FOR LEGS							Alkalinity Less than 50 ppm (mg/L)
COUNTER-TOP INSTALLATIONS MUST MAINTAIN 4” (102mm) MINIMUM								Silica Less than 12 ppm (mg/L)
							Total Dissolved Solids (tds) Less than 60 ppm
CLEARANCE FROM COUNTER SURFACE
GAS REQUIREMENTS (TYPE MUST BE SPECIFIED ON ORDER)							INSTALLATION REQUIREMENTS
CONNECTED ENERGY LOAD:			105,000 Btu / hr				Oven must be installed level.
		HOOK-UP: 3/4” NPT					Hood installation is required.
MINIMUM CONNECTED PRESSURE: 5.5” W.C. (Natural Gas)
							Water supply shut-off valve and back-flow preventer.
			9”	W.C. (Propane)
							Alternate burner orifice is required for installation sites at
MAXIMUM CONNECTED PRESSURE: 14” W.C.
							elevations of 2,000 feet (610m) above sea level.
ELECTRICAL (DEDICATED CIRCUIT REQUIRED)								12●18ESG		12●18ESG / sk
VOLTAGE	PHASE	CYCLE/HZ				AWG		AMPS	kW	AMPS	kW
110 – 120	1	50/60			NEMA 5-20P, 20A, 125V Plug, AWG 12			9.2	1.05	13.7	1.57
	OTHER VOLTAGES AVAILABLE: Range 200 – 415V – 1 or 3 ph, 50 or 60 Hz
WEIGHT			CAPACITY
NET	660 lb est	(299 kg)			FULL-SIZE PANS:		20” x 12” x 2-1/2”		Twenty-four (24)
SHIP	789 lb	(358 kg)				GN 1/1:	530 x 325 x 65mm		Twenty-four (24)
CRATE DIMENSIONS: (L x W x H)						GN 2/1:	650 x 530 x 65mm			Twelve (12)
	45” x 53” x 52”			FULL-SIZE SHEET PANS:*			18” x 26” x 1”			Twelve (12)
(1143 x 1346 x 1321mm)				ON WIRE SHELVES ONLY
							288 lb (131 kg) MAXIMUM
						VOLUME MAXIMUM: 180 quarts (228 liters)
			*ADDITIONAL WIRE SHELVES REQUIRED FOR MAXIMUM CAPACITY

COMBITOUCHTM ESG SERIES • GAS INSTALLATION MANUAL • 11.