OPE R A TIO N
DELUXE CONTROL OPERATION
1.Preheat at 200°F (93°C) for 30 minutes.
Press the ON key, and set the temperature to
200°F (93°) by using the UP/DOWN arrow keys.
Allow a minimum of 30 minutes preheating time before loading the holding cabinet with food. Closing the vents on the inside of the door will speed the preheating process. The LED heat indicator light will go “Out” after approximately 30 minutes preheat time, or when the air temperature inside the unit reaches the temperature set by the operator. The Set indicator will light up anytime the temperature is set
or reset.
2.Load with hot food only.
The purpose of the holding cabinet is to maintain hot food at proper serving temperature. Only hot food should be placed into the cabinet. Before loading the cabinet with food, use a food thermometer to make certain all products are at an internal temperature range of 140° to 160°F (60° to 71°C). Any food product not within the proper temperature range should be heated before loading into the holding cabinet.
3.Reset the control to 160°F (71°C).
Check to make certain the cabinet door is securely closed, and reset to 160°F (71°C) by using the UP/DOWN keys
THIS WILL NOT NECESSARILY
BE THE FINAL SETTING.
The proper temperature range and open or closed door vent position will depend on the type and quantity of product. When holding food for prolonged periods, it is advisable to periodically check the internal temperature of each item with a food thermometer to assure maintenance of the proper temperature range of 140° to 160°F
(60° to 71°C).
SureTemp™ Heat Recovery
The patented SureTemp™ heat recovery system in this unit will immediately compensate for any loss of heat when the door is opened. in order to maintain a more consistent cavity temperature, the control will automatically apply heat to the unit’s interior while the door is open and for a short time after the door is closed. If the door remains open for more than three minutes, the control will sound three rapid beeps every ten seconds until the door
is closed.
DOUGH PROOFING INSTRUCTIONS
SIMPLE AND DELUXE CABINETS
With the addition of a pan of water, warming cabinets can be used for proofing dough. A water reservoir pan (#1775) and pan cover (#1774) is available as an option from
1.Remove dough from retarder or refrigerator and allow covered product to set up at room temperature.
2.Set holding thermostat temperature to 95°F (35°C).
3.Pour approximately 2 quarts (c. 2 liters) of hot water into the optional water reservoir pan and place the pan on the bottom surface of the compartment. The temperature of the water should be 140° to 180°F (60° to 82°C).
4.Allow the cabinet to preheat for 45 to 60 minutes.
5.Remove covering and place dough in preheated cabinet.
6.Allow dough to remain in the cabinet until it nearly doubles in size.
7.Remove product from cabinet and bake according to product manufacturer’s directions. Brush with eggwash if desired.
Note: The above proofing procedure is a suggested guideline only. Due to variation from product to product, including quality and product weight, close adherence the product manufacturer’s
instructions is strongly recommended.
holding cabinets • installation/operation/service manual - pg. 18
