Amana RS2320006 Broil Element, Sensor, Oven Control, Flue, Leveling Leg Bracket, Side Panel

Disassembly Procedures

!WARNING

To avoid risk of electrical shock, personal injury or death; disconnect power supply source before servicing, unless testing requires it.

Broil Element

1.Turn off power to unit.

2.Remove screw securing broil element to rear of oven wall.

3.Remove screws securing element hanging clip to oven cavity.

4.Pull broil element forward enough to disconnect terminals on each element leg.

5.Reverse procedure to reinstall broil element.

Sensor, Oven Control

1. Remove screws securing SENSOR to oven liner.

2.Gently pull wires forward to access the two pin polarized disconnect plug.

3.Disconnect and reconnect new sensor.

4.Reverse procedure to reassemble.

NOTE: Verify disconnect terminal is behind the rear insulation retainer.

5. Reverse procedures to reassemble.

Flue

NOTE: Requires removal of range.

NOTE: Self-clean cycle is highly recommended before replacing flue. Ease of disassembly and reassembly is much easier.

1.Disconnect electrical supply to range.

2.Using floor protection guides, slide range forward.

3.Remove backguard shield from rear of backguard.

4.Remove screws securing smoke eliminator located inside, at top of oven cavity.

5.Pull flue out away from the range.

Replacing Flue

1.Place a thin but rugged piece of cardboard in the slot where flue goes, this holds the insulation up and out of the way for reassembly.

2.Align the smoke eliminator screen through oven and secure with screws.

3.Reassemble in reverse order.

Leveling Leg Bracket

• Remove screws securing bracket to chassis.

	Front Frame and Oven Liner
Oven Light and Oven Light Socket	Front Frame and Oven Liner are NOT field replaceable
	on these units.
1. Disconnect electrical supply to oven.

2.Wearing protective gloves unscrew the knurled “mason jar” lens cover counterclockwise about 3/4 turn and remove. Unscrew old oven light bulb.

3.Remove screws securing oven light socket to the oven cavity.

4.Pull oven light socket out through the front and disconnect wire terminals from socket.

NOTE: Reposition fiberglass insulation around oven light socket to eliminate possibility of heat related problems.

RS2320006 Rev. 0

Side Panel

1.Remove maintop, see “Maintop” procedure steps 1– 7.

2.Remove lower access panel, located on the rear of unit.

3.Remove screws securing backguard bracket to side panel.

4.Remove oven door from unit and slide oven drawer outward to gain access to screws.

5.Remove screws securing side panel to oven chassis. Screws are located on top, front, and back of unit.

6.Remove side panel by pulling outward on the back of panel and sliding panel forward.

7.Reverse procedure to reassemble.

14