Amana RS2320006 service manual Delayed Baking, Self-cleaning, Interrupting the self-clean cycle

Sigma Control Programming Instructions

Delayed Baking

Set oven to begin and end baking at a later time. Oven control automatically calculates starting time.

1.Place food in oven.

2.Press STOP TIME button.

∙Default time displayed is current time of day.

3.Use the digit pads (1 through 0) to enter the desired stop time.

∙Stop time can be set up to 11 hours and

59 minutes ahead of current time of day.

4.Press COOK TIME pad.

∙Cook time can be set up to 11 hours and 59 minutes.

∙1 minute minimum cooking time.

∙Electronic control automatically calculates start time.

5.Press BAKE pad.

∙Bake temperature can be set from 170GF to 550GF.

∙Use the digit pads to enter desired bake temperature.

6.Press START pad.

∙Oven will automatically begin to heat at calculated start time.

∙ON displays when oven begins to heat.

∙To adjust cook time, press COOK TIME pad while the remaining cook time is displayed. Cook time can then be adjusted.

∙When cooking time has elapsed an end of cycle signal sounds. Oven signal sounds 3 times, then once every 30 seconds until OVEN CANCEL pad is pressed. END also displays.

7.Press OVEN CANCEL to cancel baking.

Self-cleaning

Self-clean feature uses high oven temperature to clean oven interior. For the oven to operate through a complete self-clean cycle, the self-clean must be set when the oven is cool.

1.Prepare oven for self-cleaning.

2.Close door.

3.Press CLEAN pad.

∙SET CLEAN TIME flashes in display.

∙The default self-clean cycle length of 3 hours displays.

∙Adjust clean cycle length by using digit pads (1 through 0).

∙Clean cycle can be set from two to four hours in one minute increments.

4.Press START pad.

∙CLEAN, TIME, LOCK, ON and both bake and broil element graphics display.

∙Surface burners should not be used until completion of self-clean cycle.

∙At the end of self-clean cycle, END displays. No signal tone will sound.

∙ON no longer displays. Oven will shut off.

∙LOCK will remain on until oven reaches a cooler temperature.

∙LOCK will shut off when door has unlocked. Oven cavity will be hot to the touch.

∙DO NOT attempt to open door prior to LOCK shutting off.

Interrupting the self-clean cycle

To stop a self-clean cycle that has already started follow these steps. If an interruption occurs mid cycle, the oven will remain locked, even though the cycle has stopped, until the oven cavity has cooled to a lower temperature.

1.Press OVEN CANCEL pad.

2.When oven has cooled to a lower temperature, LOCK light turns off. Door can be opened. DO NOT force door. This can cause damage to the latch.

RS2320006 Rev. 0 D￿5