Amana RS2320006 Genesis Control Testing Information, Clean, Broil, Bake, Preheat, Locked

Genesis Control Testing Information

!WARNING

To avoid risk of electrical shock, personal injury or death; disconnect power to oven before servicing, unless testing requires it.

Mylar Overlay⎯KRC
				OVEN
	COOK		CLEAN	OFF
TIMER				WM
ON OFF	CLEAN
	TIME		BROIL
	OVEN
	LIGHT
RECALL	START
OVEN TEMP	COOK			BAKE
	CLEAN
CLOCK
	PREHEAT	LOCKED	PUSH TO TURN
Illustration	Component	Test Procedure		Results

		Genesis electronic	Measure voltage at terminals
		range control	J2−E7 (L1) and E2 (NEU)	120 VAC should be indicated, verifying
				voltage to control.
		On power-up lock	Relay drive requirements
		light will blink for	Bake⎯BA to L2	240 VAC, if not replace control.
		approximately 25	Broil ⎯BR to L2
				240 VAC, if not replace control.
		seconds, while	Bake
				75% bake element 25% broil element
		control is verifying	Broil
	J2			100% broil element
		lock latch position.	Clean
	E5		Stage 1	Time controlled 60 minutes 100% broil
		On power up, if	Stage 2
E7				50% bake element and 50% broil element
		sensor has failed.	Time (Adjustable)
	E3			2 hours minimum to 4 hours maximum
		No F−Code will be
	E4		Failure codes:
		displayed.
E2
		No oven functions	F1-Control malfunction	Verify voltage to control.
	E1
		will start.		If no voltage is present, check wiring.
				If voltage is present, replace control.
		1	F2-Oven over temperature	Check sensor resistance and wiring.
	J1	PIN		Replace control if sensor and wiring are
			F3-Oven temperature sensor	good.
			Open or Shorted	Check sensor resistance and wiring.
				Replace sensor, if wiring is good.

F9-Door latch circuit malfunction	Check latch switch and associated wiring.
Temperature Calibration	Turn oven control to OFF position.
	Press and hold both slew pads for 5 sec.
	Use slew pads to adjust temp setting.
	After 5 sec. of no input the mode is exited.

RS2320006 Rev. 0 C−2