Amana RS2320006 service manual Connect Electrical Cord, Zluh&Rug,Qvwdoohgzluh&Rug,Qvwdoohg

%ODFN￿

6WUDLQ￿UHOLHI

￿QRW￿VXSSOLHG￿ZLWK￿UDQJH￿

2CONNECT ELECTRICAL

CORD

To place electrical receptacle, see Electrical Receptacle Location diagram in this manual.

$FFHVV￿

FRYHU

Range has been grounded at the factory to the center (nickel plated) terminal of the terminal block in accordance with the National Electric Code. When a separate ground is required by local code, disconnect the grounding strap from the terminal block. Ground frame by connecting a grounding wire to range frame using the grounding strap and screw, as shown below, removed from the grounding strap.

3-wire or 4-wire Plug Connection

Four-wire cord is required for mobile homes or where codes (Canada) do not permit grounding through neutral.

1.Remove access cover from rear of range.

2.Use a strain relief (not supplied) and insert end of power cord (not supplied) through power supply hole.

3.4-wire Plug Only—Remove the green ground screw from range back. Remove both the hex nuts and the grounding strap from the center terminal. Position grounding strap down and away from terminal block. Replace 1 hex nut on the center terminal. Attach the power cord ground wire (green or bare) and grounding strap to rear bulkhead using ground screw.

4.Unscrew and use top hex nut to attach the power cord wires to the terminal block as follows:

•Red wire to “L1” terminal.

•Black wire to “L2” terminal.

•White wire to Neutral terminal.

5.Tighten all hex nuts and reinstall access cover removed in step 1.

￿￿ZLUH￿&RUG￿,QVWDOOHG￿￿ZLUH￿&RUG￿,QVWDOOHG

	1HXWUDO
￿/￿￿	￿/￿￿
	￿/￿￿
5HG￿	5HG￿
:KLWH￿	:KLWH￿
	%ODFN￿

Converting 3-Wire to 4-Wire Power Cord

1.Remove access cover from rear of range.

2.Remove bottom strain relief screw and retain for further use.

3.Remove hex nuts from terminal block and retain for further use.

4.Remove all 3-wire or cable leads from the terminal block and proceed to remove the power cord from the range by pulling in a downward motion so the cord is removed from strain relief.

5.To install the 4-wire cord, follow the 4-wire instructions shown above.

1HXWUDO

￿/￿￿

*URXQG￿

VWUDS

*URXQG

*URXQG￿ ZLUH VFUHZ

A–3 RS2320006 Rev. 0