Disassembly Procedures
!WARNING
To avoid risk of electrical shock, personal injury or death; disconnect power supply source before servicing, unless testing requires it.
Reverse Procedure to Reassemble Oven Door
•Position slot on oven door hinge arms into the hinge receivers. When slot is engaged into the hinge receivers, open the door just far enough to rotate both hinge locking tabs to the UNLOCK position.
Oven Door Gasket
The braided fiberglass oven door gasket is clipped at intervals in holes around the front of the oven liner then inserted into a
A 6 1/2
1. Unclip original gasket from front frame and pullout ends from
2. Remove two knurled nuts securing oven bottom in position. Remove oven bottom.
3. Divide oven gasket in half and insert center clip into top center hole in the front frame. Proceed inserting clips left and right.
4. Push gasket through the
4.Place control panel on a protective padded surface with the control down. Remove screws securing electronic control to mounting bracket. There is sufficient extra wire length to move electronic control out of the way while installing new control. Transfer electrical wires/connectors one at a time to new control.
NOTE: When reinstalling control panel, be certain the fiberfax insulation and it’s galvanized retainer is above the flue cutout in control panel. Insulation and retainer are NOT visible when correctly positioned. Verify backguard heat shield (above flue) is inside backguard panel and not visible when installed.
5. Reverse procedure to reattach control panel to range.
Infinite Switch
1.Turn off power to unit.
2.Remove backguard, see "Electronic Control" procedure.
3.Disconnect and label wire terminals.
4.Remove infinite switch knob from infinite switch.
5.Remove screws in front securing infinite switch.
6.Reverse procedure to reinstall.
Indicator Light
Electronic Control
1.Turn off electric supply to oven.
2.Using a “stubby” phillips screwdriver remove the offset screws from the bottom front of control panel.
| Clock | |
| Infinite | |
| switch | |
| Indicator | |
| light | |
Offset | Rocker | |
switch | ||
screws | ||
|
1.Turn off power to unit.
2.Remove backguard, see "Electronic Control" procedure.
3.Disconnect and label wire terminals.
4.Slide indicator light sideways to release from indicator light lens.
5.Reverse procedure to reinstall.
3.Rotate bottom of control panel outward, then lift up to disengage top tabs.
RS2320006 Rev. 0 | 12 |