How to Add Circuit Breakers and Power Cables

Add a circuit breaker on the PDU

1. Snap and bolt the new circuit breaker into a position on the panel.

2. Remove the corresponding plastic blanking plate on the front panel of the PDU.

Add a power cable to the PDU

Before adding a power cable, add a circuit breaker.

1. Install a strain-relief connector in any available knockout on the roof of the PDU.

2. Slide enough of the power cable through the strain-relief connector to reach the

new circuit breaker. 3. Tighten the strain-relief connector.

Note

Note

If you must install at 20A or 30A power cable in a knockout designed for a 50A power cable, you must use reducing washers (included) to adjust the size of the hole.

If you are adding a power cable that will attach to a circuit breaker on the bottom circuit breaker panel, use a non-conductive fish tape to feed the power cable down the rectangular wireway (chute) in the center of the PDU. This will allow you to easily access the bottom circuit breaker panel.

50

60 kW InfraStruXure PDU — Operation and Configuration

Page 58
Image 58
American Power Conversion PD60L6FK1 manual How to Add Circuit Breakers and Power Cables, Add a circuit breaker on the PDU