Surge Protection
The S10 and S15 provide guaranteed protection against damaging surges, spikes and even lightning strikes. The
Isolated Noise Filter Banks
Both the S10 and S15 eliminate electromagnetic and radio frequency interference (EMI and RFI) that, when severe enough, can negatively impact sound and video quality. Each filter bank is electrically isolated from the other filter banks to prevent noise generated by one component from polluting other connected components. APC's noise filtering helps enable your system perform to its maximum capabilities.
DC Trigger
This only works with devices that support DC triggering. When the unit is connected to a device that is acting as a DC trigger, the device controls when the ‘delayed outlet banks’ are turned on and off. The S10 and S15 can also allow the DC signal to pass through to another connected device. For more information on how triggering works, or to determine if your system has this capability, refer to your equipment owner’s manual.
!trigger source to the IN jack. The OUT jack should only be used as a
not apply an AC voltage to the DC trigger jacks. Failure to comply with this Caution may damage your equipment.Caution: When connecting to the DC Trigger jacks, connect the DC
Rack-mountable
ON/OFF Sequencing
This feature ensures connected equipment is powered up and powered down in the proper sequence, with the right amount of delay between stages. It allows you to program a delay into a sequence ranging between 0 and 10 seconds. This delay eliminates transients that can affect connected components, or that may cause the building circuit breaker to trip.
