3.Rotate the green Printhead Latch counterclockwise to open the printhead.
4.Rotate the Side Access Door down to allow the media to be loaded under the printhead module.
Printhead Latch
Upper Media Sensor Arm
Lower Media Sensor Arm
Side Access Door
Figure 14 - Printhead Latch and Side Access Cover
5.Slide the Media Supply Guide to the full widest position.
6.Ensure the media is face out with the labels feeding from the top of the roll. If not obtain correctly wound media from your supplier
7.Place the media roll on the Media Supply Spindle.
8.Slide the roll fully towards the center of the printer.
9.Slide the Media Supply Guide towards the center of the printer until it is snug against the media.
