15.Grasping the Sensor Adjust Knob and sliding in or out as needed can move the Media Sensor. This is required only if the sensor must be moved to a specific location on the label to detect a notch (hole) or gap.
Figure 16 - Media Sensor Adjust Knob
16.Important: To ensure proper media feeding and sensor operation, complete the following checklist:
qMedia is wound Face Out (print side out) and feeding off the top of the roll.
qMedia is routed exactly as shown over the Back Media Rail and under the Front Media Rail.
qMedia is routed between the Upper and Lower Media Sensor Arms located under print module.
qThe green Outside Media Guide has been
qIf required, the media sensor is adjusted directly over the notch (hole) or gap.
