Set-up Mode Selection Items
Item | Range | Factory Default | Remarks |
|
|
|
|
CUT/PEEL POS (mm) | + 015 to + 015 | 0 mm | Controls cut and peeling position. |
|
|
|
|
PRINT OFFSET (mm) | + 015 to - 008 | 0 mm | Controls start vertical print position. |
|
|
| Positive value only. |
|
|
|
|
TPH VER OFFS(mm) | + 003 to - 003 | 0 mm |
|
|
|
|
|
RECOVERY PRINT | ENABLE | ENABLE |
|
| DISABLE |
|
|
1GAP HEIGHT | MORE THAN 10, | MORE THAN 10 |
|
| 5 to 7 mm, | mm |
|
| 8 to 9 mm. |
|
|
2CUTTER ROTATION | NORMAL (~4”), | NORMAL (~4”) | 2”, 3” and 4”(inches) stand for the |
| MORE (<3”), |
| label width. Setting proper width can |
| MORE (<2”) |
| avoid jam. |
|
|
|
|
2CUTTER TYPE | TYPE I, | TYPE I | Enable the type of cutter mechanism |
| TYPE II |
| is installed |
|
|
|
|
COMPRESSED FLASH | NO | NO |
|
| COMPRESSION, | COMPRESSION |
|
| COMPRESSED |
|
|
WIN CON LEN (mm) | 0 to 254 mm | 0 mm | This takes effect only when you run |
|
|
| under Windows with bundled printer |
|
|
| driver and use continuous media. |
|
|
|
|
BASE SPEED (IPS) | 0 to 4 IPS | 0 IPS | This is for the PPLB emulation only. |
|
|
| When you choose TLP2642/3642 |
|
|
| driver the speed is limited under 2 |
|
|
| ips. |
|
|
|
|
COUNTER ON LCD | ENABLED, | ENABLED |
|
| DISABLED |
|
|
MEDIA SENS. TYPE | REFLECTIVE | REFLECTIVE | Select the proper type by the media |
|
| characteristics. Do calibration before | |
|
|
| printing. |
|
|
|
|
2CUTTER SIGNAL | CHECKED, | CHECKED | For general media, set it to |
| IGNORED |
| “CHECKED” except for thick media. |
|
|
|
|
BACKFEED | DISABLE, | DISABLE | This feature enables a manual |
| ENABLE |
| Present function. It can be disabled |
|
|
| by a software command. |
|
|
|
|
3BACK DISTNCE(mm) | 010 to 040 | 012 | This is the distance the printer will |
|
|
| move the form to a Presentation |
|
|
| position. |
|
|
|
|
1
2
3
Displayed only when Switch 4 is on. Displayed only when Switch 3 enabled
Displayed only when the BACKFEED feature is enabled.
