Delta Installation - Quick Start Steps
3
Delta Series Quick Start Guide
Delta Installation - Quick Start Steps
1. Connect the Source Units to Delta
Plug RCA audio cables from each source device into the labeled RCA jacks at the back of the Delta
Controller. Ensure that right and left are connected correctly. Then connect the IR emitter leads for each
audio source into the appropriate connector on the back of the Delta Controller and run the optical end of
the emitter lead to the source device’s IR receiver window.
Attach the emitter by peeling and sticking the supplied adhesive patch on the emitter. If an on-board
tuner is pre-installed into Delta, you must also connect AM and FM antennas as shown in FIG. 1.
Source Inputs (up to 4)
RCA connections for 2-channel audio input from up to 4 external sources (unless an AM/FM tuner board
is present, which internally takes up the Source #1 location - then it’s 3 additional sources). The
illustration at left shows an example of a DVD player, CD player, and iPod docking device all connected
to Delta. The fourth source is the internal AM/FM tuner.
FIG. 1 Connect the Source Units to Delta
AM/FM Antenna Inputs
Plug in the IR Emitters to the
appropriate source number
IR Emitter Outputs (4)
Connections for IR emitter
outputs that control the sources
Source Inputs (up to 4)