Programming the Delta System
42 Delta Series Audio Controllers
Begin labeling the room using the same method as the IR command and source programming from
previous pages, selecting the center button to move to the next character. If the room has not already
been labeled or defined, RM1-RM6 will be displayed for each zone. Any room can be named whatever
the user wants (within the character selections) but is limited to 6 characters per zone. Once the
characters have stopped flashing, the user can select another room to label by using the navigation
buttons.
Check Room Status
To see the status of a room, select “Status” from the “Room Information” screen. The resulting screen
will show each zone with a status next to it (FIG. 40).
If a keypad has been connected to a zone and everything is okay, the software/firmware version number
will be displayed to the right of the room name. If the status of the room is other than normal, the version
# will be replaced with a status message (up to 8 characters) of the problem:
If you choose not to label a room and delete all the characters so only blank spaces
appear, when the room is activated there will be no text label shown on the Delta
Controller front panel. This will not affect the room operation in any other way, it just
may be confusing for some users if there is no text displayed for the room in question.
FIG. 40 Check Room Status
Status Values
Status Values Message Displayed
Version # V#
Not Responding NOT RESP
Corrupt CORRUPT
Bad BAD
Room Available RM AVAIL