Delta Series Audio Controllers
2Delta Series Audio Controllers
Tuner Antenna Details
The TA-MOD tuner automatically becomes source #1 when installed into the Delta Controller
The TA-MOD tuner requires a 75 Ohm F-Type connection to receive FM stations.
The TA-MOD tuner requires an AM antenna loop to receive AM stations.
Delta Series Product Specifications (Cont.)
• LCD Display Screen Displays information necessary during the programming steps and
afterward is the display to indicate information about the source input
and zone activity.
Rear Panel Components:
• Power Switch & Receptacle The master power switch will remain in the ON position normally.
• AM/FM Antenna Inputs Connections for the AM and FM Antennas.
• IR Outputs (4) Four 3.5mm IR Emitter Output Jacks.
Note: Be sure to connect the emitter to the same numbered port as
the corresponding source input.
• Zone Outputs (up to 6) Connections for zone outputs that connect to the keypads.
• RJ 45 Port Ethernet Port for future expansion
• RS-232 and USB Ports For firmware upgrades and interface with NetLinx control systems.
• Source Inputs (up to 4) RCA connections for 2-channel audio input from up to 4 external
sources (unless an AM/FM tuner board is present, which internally
takes up the Source #1 location - then it’s 3 additional sources).
• Preamp Outputs RCA outputs to run an external amplifier. This is only available for
Zone output #1.
Dimensions (HWD) - including feet and
rear connectors:
• 3 1/16” x 17” x 13 1/2”
• 7.68cm x 43.18cm x 33.52cm
Weight: 24.05 lbs (10.91 kg)