TROUBLESHOOTING
I get an error message when trying to run the Antex Demo program.
1.Card did not install correctly because of an I/O or interrupt conflict. In Win NT, go to “Start”, “Settings”, “Control Panel”, “Multimedia”, “Devices”, “Audio Devices”, “Audio for Antex Digital Audio Driver”, “Settings”. In this dialog box, make sure the correct model Antex Audio Card is selected, and try changing the Interrupt number and/or Address.
In Win 95/98, go to “Control Panel”, “System”, “Device Man- ager”. Click the “+” sign next to “Sound, video, and game controllers”. Select the Antex card, then click on “Properties”. Select the “Resources” tab, and try changing the Interrupt Re- quest or Input/Output Range. Make sure you select a valid setting for the Antex card and that the dialog box shows that there are no conflicting devices in your system at the selected Interrupt or I/O range.
If you suspect another card in your system may be conflicting with the Antex Card, power down your computer and remove any cards you think may be conflicting and try again. Also, in the CMOS settings for your motherboard, make sure the Inter- rupt you are trying to use is “Reserved for ISA”.
2.Make sure the Antex Driver is running. In Win NT, go to “Start”, “Settings”, “Control Panel”, “Devices”. Check the An- tex Digital Audio Driver and make sure it is Started and on Automatic.
3.Try removing and
46
