CHAPTER 4: INSTALLATION
17
Unpacking The UPS and accompanying components is packaged in a robust shipping carton. Carefully remove the package
contents. The UPS and modular components are shipped on one or more pallets, depending on the configuration.
The packaging is recyclable; save it for reuse or dispose of it properly.
Inspection
Inspect the equipment upon receipt. APC has designed robust packaging for your product. However, accidents
and damage may occur during shipment. Notify the carrier and dealer if there is damage or missing equipment.
Contents
Check the packaging contents. Two shipping pallets are included:
(1) Boxed UPS, shrink-wrapped on a pallet.
• Transportation cart
• Rail kit (containing the mounting rails and hardware),
• Accessory bezel kit (containing two transportation cart brackets, display bezel with Powerview, four blank
bezels, blank panel kit, and literature kit
(2) Individually boxed and shrink-wrapped p ower and battery modules.
The number of each depends on the configuration ordered.
Installing the UPS This section provides information on the steps required to install and connect the UPS.
The UPS is designed for use in a data center or other office environment. Refer to Chapter 3: Site Preparation to
select a location.
Moving the UPS to the Installation Site
• The UPS is heavy. Two people, one on each side, must support the UPS when it is being
transported on the cart to the rack; installed, or removed from the rack.
• A qualified electrician must install or remove battery modules.
• Two people are required to lift, move, install, or remove battery and power modules. The
battery and power modules are heavy.
Do not install battery modules until you are ready to power up the UPS. Batteries can be
permanently damaged if loaded prematurely.
• To comply with FAA regulations, the battery modules are shipped disconnected to
the UPS.
• Mounting rails are included with the UPS. The rails support the unit in the rack.